Sole Agent of Centon Water Heaters in Kenya

MON-FRI 8:00 am - 4:00 pm SAT 9:30 am - 2:00 pm Tel: +254 722 722 749

Decostyle DS1EP

Our Top of the Range single point instantaneous shower heater, the Decoration Series Decostyle DS1EP comes with a provision for 3 type of installation, Top Installation, Embedded Installation or Bottom Installation. No messy and unsightly piping or exposed Stop Valve.

The built in pump, with a 120W motor gives up to 4 1/2 times more shower. The double bearings pump motor design is more durable and quieter. Extra feature, of pump Speed Control enables user to select shower flows.

A 15mm. diameter internal tubing ensures more water flow and the built in Stop Cock enhances the Aesthetic of the unit as a Bathroom fitting.

deco-install

 

12 Points Safety

12d
  • Built-In Attached Temperature & Water Valve Knobs meets IPX5 Jet Proof Standard.
  • Rubber Seal Heater Cover & Base Design Provide Jet Proof
  • Quality Terminal Block Meets CE/UL/VED Standards
  • Earth Safety Line Fault Detector(Refer below)(Optional Feature)
  • ELCB As Sensitivity As 15 mAmp Would Automatically Cut-Off Power Supply In the Event Of Current Leakage &Prevent Electrocution.
  • UL Standard Cables With 105?C Temperature Rating.
  • Secured Stainless Steel Screw Mounting Prevent Arcing &Spark Occuring In Cable Connection.
  • Anti Leak Clamp Tank Design With 7 Years Anti Leak Tank Warranty Provide Additional Safety To Users.
  • Pressure Switch Triggering System Only Operates Only When There Is Sufficient Water Pressure.
  • Heating Element Only Activate When There Is Water Flow As A Result Of Activating(By Pressing)The’ON/OFF’Button.
  • Thermostat Automatically Cut-Off At 55?C Acts As Anti Scalding.
  • Outlet Come With Pressure Relieve Device Which Only Activate At A Design Water Pressure Above 90 psi.
12c

 

 New Stop Valve ON/OFF System
The new state-of-the-art user friendly ON/OFF built-in stop valve system operate by just a touch of this button would activate and deactivate the heater system and shower flows.

 

Technical Specifications and Standards

  • Heater Electrical Rating – Available in 6.0 kW, 220-240V A.C, 50/60Hz
  • Minimum Water Flow Rate – 0.21kg f/cm2 (3psi)
  • Maximum Water pressure – 3.87kg f/cm2 (55psi)
  • Water Temperature Control – Electronic Control
  • Water Connection – 15mm dia. (1/2″ BSp)
  • Dimensions – 220mm x 330mm x 96mm (H)
  • Weight – 5.0kgs
  • pump Electrical Rating – 120W, 220-240VA.C, 50/60Hz
allproducts

Author Info

edge

No Comments

Comments are closed.